METAL PROCESSING | |
Название | Mn – Al hard magnetic alloys |
Автор | Alymov M. I., Milyaev I. M., Nurislamov A. Kh., Yusupov V. S. |
Информация об авторе | Institute of Structural Macrokinetics and Materials Science of Russian Academy of Sciences, Chernogolovka, Russia: M. I. Alymov, Director
A. A. Baikov Institute of Metallurgy and Materials Science of Russian Academy of Sciences, Moscow, Russia: I. M. Milyaev, Leading Researcher
A. Kh. Nurislamov, Leading Engineer |
Реферат | The purpose of this review is to pay the attention of contemporary researchers and process engineers to Mn – Al hard magnetic alloys. The extensive research of Mn – Al hard magnetic alloys were made in the 1960–1970s. The alloys had great potential for practical application in various fields of industry due to sufficiently high values of the coercive force, along with the maximum magnetic energy, and due to the fact that source charge materials had a low cost. Only Japan and the USA have managed to produce these alloys because of the high cost of manufacture. After 1980s the interest to Mn – Al hard magnetic alloys was lost, which reason was the experts' forecast. They had predicted that the alloys, existed before industrial hard magnetic ones, including hard magnetic ferrites, would be replaced by Nd2Fe14B after the 2000s. However, this did not happen, and it will not apparently occur because of the limited resources of rare earth. In several cases, Mn – Al hard magnetic alloys can successfully replace magnetic alloys, based on rare earth compounds. Since the 1980s, the significant changes in the field of quality in alloy production technology have been made. It gives the hope that the cost of production of magnetic Mn – Al alloys will be reduced. The results of experimental technology of Mn – Al – C permanent magnet alloy are mentioned in this review briefly. This experimental technology was developed at the end of 1980s of the last century by one of the authors of this review in the Institute for Metals Superplasticity Problems of Russian Academy of Sciences (Ufa). For some reasons the technology has not been adopted in industry, but now it may serve as a good basis for the future development of these promising magnetic materials. |
Ключевые слова | Hard magnetic alloys, magnetic properties, coercive force, saturation magnetization, maximum energy product, ferromagnetic phase, alloying, plastic deformation |
Библиографический список | 1. Burkhanov G. S., Milyaev I. M., Yusupov V. S. Sovremennoe sostoyanie i tendentsii razvitiya magnitotverdykh materialov (Modern state and tendencies of development of hard-magnetic materials). Perspektivnye materialy = Journal of Advanced Materials. 2011. No. 11. pp. 208–215. 2. Coey J. M. D. Magnetism in future. Journal of Magnetism and Magnetic Materials. 2001. Vol. 226-230. pp. 2107–2112. 3. Muller K.-H., Krabbes G., Fink J., Gru S., Kirchner A., Fuchs G., Schultz L. New permanent magnets. Journal of Magnetism and Magnetic Materials. 2001. Vol. 226–230. pp. 1370–1376. 4. Kubo T., Ohtani T., Kojima S., Kojima K., Sakamoto Y. et al. Machinable anisotropic permanent magnets of Mn – Al – C alloys. Patent US, No. 3976519. Published: 23 July 1974. 5. Hindrichs G. Uber einige Chrom- und Manganverbindungen. Zeitschrift fur analytische Chemie. 1908. No. 59. pp. 414–449. 6. Kono H. On the ferromagnetic phase in manganese-aluminum system. Journal of the Physical Society of Japan. 1958. Vol. 13, Iss. 12. pp. 1444–1451. 7. Diagrammy sostoyaniya dvoynykh metallicheskikh sistem : spravochnik : v 3 tomakh. Tom 1 (State diagrams of double metallic systems : reference book : in three volumes. Volume 1). Under the general editorship of N. P. Lyakishev. Moscow : Mashinostroenie, 1996. 992 p. 8. Koch A. J. J., Hokkeling P., Van der Steeg M. J., De Vos K. J. New material for permanent magnets on a base of Mn and Al. Journal of Applied Physics. 1960. Vol. 31, Iss. 5. pp. 75–77. 9. Magat L. M., Shur Ya. S., Kandaurova G. S., Makarova G. M., Guselnikova N. I. O kristallicheskoy strukture i magnitnykh svoystvakh vysokokoertsitivnogo splava Mn – Al (About crystalline structure and magnete properties of high-coercive Mn – Al alloy). Fizika i khimiya obrabotki materialov = Physics and Chemistry of Materials Treatment. 1967. Vol. 23, No. 2. pp. 226–233. 10. Shur Ya. S., Kandaurova G. S., Magat L. M., Bykhanova N. N. Magnitnye svoystva poroshkov vysokokoertsitivnogo splava Mn – Al (Magnetic properties of powders of high-resistive Mn – Al alloy). Fizika i khimiya obrabotki materialov = Physics and Chemistry of Materials Treatment. 1966. Vol. 22, No. 1. pp. 39–44. 11. Kono H., Makino N., Kimura Y., Suzuki M. Journal Japan Institute of Metals. 1964. Vol. 28, Iss. 8. p. 483. 13. Kavalerova L. A., Milyaev I. M. Obmennaya anizotropiya v splavakh na osnove sistem Mn – Al i Mn – Al – C (Volumetric anisotropy in alloys on the basis of Mn – Al and Mn – Al – C systems). Elektronnaya promyshlennost = Electronic industry. 1984. Iss. 5. pp. 66–67. 14. Makino N., Kimura Y., Suzuki M. Heat Treatment and Magnetic Properties of the MnAl Alloy. Transactions of the Japan Institute of Metals. 1965. Vol. 6, No. 1. pp. 53–57. 15. Nobuyuki K., Hiroshi Y. Manufacturing method for magnetic alloy. Patent 16857 JP. Applied: 28 July 1964. Published: 09 August 1967. 16. Nurislamov A. Kh. Obrabotka v sverkhplasticheskom sostoyanii magnitotverdykh splavov sistemy Mn – Al – C. Dissertatsiya … kandidata tekhnicheskikh nauk (Processing of hard-magnetic Mn – Al – C system alloys in over-plastic state. Thesis of inauguration of Dissertation ... of Candidate of Engineering Sciences). Ufa, 1988. 141 p. 17. Kaybyshev O. A. Plastichnost i sverkhplastichnost metallov (Plasticity and over-plasticity of metals). Moscow : Metallurgiya, 1975. 280 p. 18. Livshits B. G., Milyaev I. M., Okhrimenko Ya. M., Tyurin V. A. O deformiruemosti splavov Mn – Al (About deformation ability of Mn – Al alloys). Fizika i khimiya obrabotki materialov = Physics and Chemistry of Materials Treatment. 1970. No. 3. p. 136. |
Language of full-text | русский |
Полный текст статьи | Получить |