Journals →  Non-ferrous Metals →  2015 →  #1 →  Back

LIGHT METALS, CARBON MATERIALS
ArticleName Fluorination of alumina sand type during exhaust gases treatment of aluminum reduction process
DOI 10.17580/nfm.2015.01.06
ArticleAuthor Pyaterneva A. A., Bazhin V. Yu.
ArticleAuthorData

National Mineral Resources University (Mining University), Saint Petersburg, Russian Federatation:

A. A. Pyaterneva, Post-Graduate, Department of Metallurgy
V. Yu. Bazhin, Professor, Dean of mineral raw materials processing faculty

Abstract

Exhaust gases of aluminum reduction process in cells with prebaked anodes has a high content of fluoride, dust and hydrogen oxides. Under the modern ecological standards, aluminum plants are the ecological hazard and obey regulations on the maximum permissible emissions. The hazardous emission sources in the aluminum production are the crude products and consumables. The main sources are alumina, coal anode material (pre-baked coal anodes) and fluoride salts. During aluminum reduction process fluoride emissions have the greatest impact. Almost total fluoride emissions are entrapped in the system of dry gas treatment where alumina sand type is used as an active adsorbent. In transition to a technology with low cryolite ratio, it becomes even more important to stabilize composition of electrolyte since the operating mode with the low cryolite ratio is more sensitive to exposure and production impact. For that reason, the composition of electrolyte and other process parameters can suffer imbalance. Under higher amperage, fluoride emissions from the surface of electrolyte grows since aluminum fluoride partly adsorbed at the cryolite-alumina crust evaporates most intensively at low cryolite ratio and under temperature fluctuations. Main flow of volatile matters with fluoride goes with industrial gases (hydrogen oxide and dioxide) in the system of gas treatment where it flows through the bed of alumina sand type in adsorbingreactor. Fluorinated alumina is one of the items in the fluoride balance in aluminum electrolysis, and its change is governed by the change in specific consumption of all fluoride salts. The technology of dry cleaning of electrolysis gases is so far the most ecology-friendly process, and return of secondary alumina (after the dry gas treatment) in the electrolysis enables reduction in fluoride flow. This article discusses the issue of adsorption capacity of metallurgical alumina, which is closely related with the performance of dry gas treatment plants for removal of fluoride compounds from aluminum reduction process industrial gases. The authors have carried out laboratory bench testing of alumina sand type in the flow of exhaust gases from the surface of cryolite-alumina melt. As a result, new data of fluorides chemical adsorption process on the surface of alumina sand type are obtained and efficient operating mode of dry gas treatment system is identified.

keywords Primary aluminum, fluorinated alumina, aluminum reduction process, dry gas treatment, adsorbing reactor, specific surface, adsorption capacity
References

1. Chzhen V. A., Burkat V. S., Utkov V. A., Sambueva E. A. Minimizatsiya negativnogo vozdeystviya predpriyatiy alyuminievoy promyshlennosti na okruzhayushchuyu sredu (Minimization of negative impact of aluminium industry enterprises on environment). Metallurg = Metallurgist. 2008. No. 11. pp. 41–45.
2. Sleppy W. C. Aluminum compounds. Kirk-Othmer Encylopeia of Chemical Technology. Under the editorship of Kroschwitz J. I., Howe-Grant M. N. Y.: John Wiley & Sons, 1992. Vol. 2. pp. 252–267.
3. Grjotheim K., Kvande H., Motzfeldt K., Welch B. The formation and composition of the fluoride emissions from aluminum cells. Canadian Metallurgical Quarterly. 2012. Vol. 11, No. 4. pp. 585–599.
4. Patterson E. C. Hydrogen Fluoride Emissions From Aluminium Electrolysis Cells : PhD Thesis. The University of Auckland. New Zealand, 2002.
5. Hyland М., Metson J., Haverkamp R., Welch B. Surface studies of hydrogen fluoride adsorption on alumina. Light Metals. 1989. pp. 113–118.
6. Wagener J. B., Hancke J. J., Carstens P. A. Adsorption of HF on alumina. Journal of Thermal Analysis. 1993. Vol. 39. pp. 1069–1077.
7. Dando N. R. Adsorption/entrainment of fluoride in smelting grade alumina: surface chemical speciation and adsorption mechanism. Light Metals. 2005. pp. 133–139.
8. Gillespie A. R., Hyland M. M., Metson J. B. Irreversible HF adsorption in the dry-scrubbing process. Journal of the Minerals Metals & Materials society. 1999. Vol. 51, No. 5. pp. 30–32.
9. Haupin W., Kvande H. Mathematical model of fluoride evolution from Hall-Heroult Cells. Light Metals. 1993. pp. 257–263.
10. Grjotheim K., Welch B. J. Aluminium smelter technology. Second edition. Dusseldorf: Aluminium-Verlag, 1988.

Language of full-text english
Full content Buy
Back