Journals →  Non-ferrous Metals →  2017 →  #2 →  Back

RARE METALS, SEMICONDUCTORS
ArticleName Sorption of non-ferrous metal cations on hydrated titanium dioxide
DOI 10.17580/nfm.2017.02.05
ArticleAuthor Maslova M. V., Gerasimova L. G.
ArticleAuthorData

I. V. Tananaev Institute of Chemistry and Technology of Rare Elements and Mineral Raw Materials (Kola Science Center, RAS), Apatity, Russia:

M. V. Maslova, Leading Researcher, e-mail: maslova@chemy.kolasc.net.ru
L. G. Gerasimova, Chief Researcher

Abstract

Adsorption properties of ion-exchange material based on spherical hydrous TiO2 particles (HTD) in regards to non-ferrous metal cations has been investigated. TiO2 particles were synthesized by the sol-gel method. The high stable titanium sol (IV) was obtained by the method of limited hydrolysis of ammonium titanyl sulfate (NH4)2TiO(SO4)2·H2O (ATS) solution without the usage of organometalic compounds. The presence of ammonium ion in sol prevents the polymerization of gels, which has a positive impact on porosity of the obtained compounds and, consequently, on ion-exchange properties. The synthesized material is weakly-acidic ion-exchanger, pK value of functional groups to be determined as рК1 = 5.28 and рК2 = 7.88. The total ion-exchange capacity equals 4.0 mg-eq/g towards sodium cation. This article presents the adsorption behavior of non-ferrous metal cations using HTD during technological wastewater purification. The cations were selected based on their ubiquity in wastewater of different industrial processes. The maximum ion-exchange capacity of the researched cations as well as quantitative characteristics of the sorption process was estimated. According to the maximum exchange capacity the selectivity order of the metal ions on HTD is determined as follows: Pb2+ > Co2+ > Cu2+ > Ni2+ > Sn2+ > Cd2+ > Zn2+. The obtained sorption data are best elucidated by the Freundlich model for cadmium and lead cations, and by Langmuir and Freundlich models in the case of sorption of zinc, copper and nickel cations. The sorption kinetics of these metal ions on HTD shows that the internal diffusion processes play a main role. The tests on purification of water from hardness salts and polyvalent metals in dynamic regime were performed to evaluate the functional properties of HTD. It was shown that HTD has an increased capacity in regards to divalent metal cations and low selectivity to hardness cations as compared to carboxylic cation exchanger С-104 (“Purolite”). In the case of wastewater treatment in tannery industry, the sorption of chrome cations by HTD exceeds 99% in all the researched systems, whilst the remaining concentration of chromium ions (III, VI) in the solution is lower than PMC.

The researches were conducted with the financial support of Russian Science Foundation (RSF) as a part of the scientific project 17-19-01522.

keywords Hydrous titanium dioxide, adsorption properties, kinetics, sorption isotherms, wastewater treatment, chromium (III), chromium (VI), polyvalent metals
References

1. Pathak S. S., Bhanushali R. D., Pius I. C., Mukerjee S. K. Preparation of porous titania–silica microspheres for treatment of radioactive waste. Radioanalytical and Nuclear chemistry. 2013. Vol. 295. pp. 1641–1648.
2. Engates K., Shipley H. Adsorption of Pb, Cd, Cu, Zn and Ni to titanium dioxide nanoparticles: effect of particle size, solid concentration on exhaustion. Environmental Science and Pollution Research. 2011. Vol. 18. pp. 386–395.
3. Bhat S. C., Goswami S., Palchaudhury S., Ghosh U. C. Pb(II) sorption performance of hydrated titanium(IV) oxide from aqueous solution. Indian Chemical Society. 2005. Vol. 82. pp. 632–636.
4. Debnath S., Ghosh U. C. Kinetics, isotherm and thermodynamics for Cr(III) and Cr(VI) adsorption from aqueous solutions by crystalline hydrous titanium oxide. Chemical Thermodynamics. 2008. Vol. 40 (1). pp. 67–77.
5. Nitoi I., Oancea P., Raileanu M., Crisan M., Lucian Constantin L., Cristea I. UV–VIS photocatalytic degradation of nitro benzene from water using heavy metal doped titania. Industrial and Engineering Chemistry. 2015. Vol. 21. pp. 677–682.
6. Herregods S., Mertens M., Van Havenbergh K., Van Tendeloo G., Cool P., Buekenhoudt A., Meynen V. Controlling pore size and uniformity of mesoporous titania by early stage low temperature stabilization. Colloid and Interface Science. 2013. Vol. 391. pp. 36–44.
7. Seck E. L., Doña-Rodríguez J. M., Melián E., Fernández-Rodríguez C., González-Díaz O. M., Portillo-Carrizo D., Pérez-Peña J. Comparative study of nanocrystalline titanium dioxide obtained through sol-gel and sol-gel-hydrothermal synthesis. Colloid and Interface Science. 2013. Vol. 400. pp. 31–40.
8. Jolivet J.-P., Сassaignon S. Design of oxide nanoparticles by aqueous chemistry. Sol-Gel Science and Technology. 2008. Vol. 46 (3). pp. 299–305.
9. Pal M., Serrano J. G., Santian P., Pal U. Size-controlled synthesis of spherical TiO2 nanoparticles: morphology, crystallization, and phase transition. Journal of Physical Chemistry C. 2007. Vol. 111 (1). pp. 96–102.
10. Maslova M. V., Gerasimova L. G., Knyazeva A. I. Synthesis of sorbent based on hydrated hydroxooxotitane. Zhurnal Neorganicheskoy khimii. 2015. Vol. 60, No. 4. pp. 1–7.
11. Gerasimova L. G., Maslova M. V., Matveev V. A., Mayorov D. V., Kobgunov N. N. Titanium-phosphate sorbents for purification of liquid flows from radioactive, non-ferrous and heavy metals. Tsvetnye Metally. 2005. No. 3. pp. 87–91.
12. Kokotov Yu. A., Zolotarev P. P., El’kin G.E. Theoretical foundations of ion exchanging: Complex ion-exchanging systems. Leningrad : Khimiya, 1986. 280 p.
13. Ho Y. S., MacKay G. A comparison of chemosorption kinetic models applied to pollutant removal on various sorbents. Transition metal chemistry. 1998. Vol. 78. pp. 332–340.

Full content Sorption of non-ferrous metal cations on hydrated titanium dioxide
Back