Журналы →  Gornyi Zhurnal →  2018 →  №4 →  Назад

THEORY AND PRACTICE OF PRODUCTION
HYBRID GEOTECHNOLOGY: RESOURCE-SAVING AND ENERGY EFFICIENCY
Название In-situ stress measurement in rocks, considering specificity of hybrid mining
DOI 10.17580/gzh.2018.04.04
Автор Balek A. E., Panzhin A. A., Konovalova Yu. P., Melnik D. E.
Информация об авторе

Institute of Mining, Ural Branch, Russian Academy of Sciences, Yekaterinburg, Russia:

A. E. Balek, Leading Researcher, Doctor of Engineering Sciences, balek@igduran.ru
A. A. Panzhin, Academic Secretary, Candidate of Engineering Sciences
Yu. P. Konovalova, Researcher
D. E. Melnik, Post-Graduate Student

Реферат

The article describes the innovative procedure of in-situ stress measurement by the borehole slotting method at long spacing and time base (from hundred metes to tens kilometers and over periods of tens years) with regard to specific features of hybrid open pit/underground mineral mining. Stresses are calculated by solving inverse geomechanical problem on measured displacements at points set in large test areas in the influence zones of open pit mines and underground caving. Their integrated effect is considered under ground conditions of geodynamically active enclosing rock mass by means of recording displacement of reference geodetic points relative to the permanent geodetic stations of ITRF Network. The application of the new procedure is described in terms of the typical hybrid mining operations at the Sokolov iron ore deposit. The in-situ measurements included horizontal displacements taken at 26 points of the state geodetic network deployed in 1972 on the surface of the Sokolov–Sarbai iron ore field with an area of 400 km2 and at 28 points of the reference surveying network installed in 1978 in the proximity of the Sokolov open pit and underground mines. The measurements are taken using two-system (GPSGLONASS) two-frequency Sokkia GRX-1 receiving stations with the rated horizontal accuracy of 3–5 mm and vertical accuracy of 5–7 mm.
This study was supported under State Contract No. 007-00293-18-00, Topic No. 0405-2015-0012.

Ключевые слова Hybrid geotechnology, geological medium, modern geodynamic activity, full-scale research, mathematical modeling, inverse problem solution, stress state, Sokolov iron ore deposit
Библиографический список

1. Balek A. E., Sashurin A. D. Problem of evaluation of natural stress-strain state of rock mass during development of mineral resources. Gornyy informatsionno-analiticheskiy byulleten. 2016. Special issue No. 21. Problems of complex mastering of georesources. pp. 9–23.
2. Sainoki A., Mitri H. S. Dynamic behaviour of mining-induced fault slip. International Journal of Rock Mechanics & Mining Sciences. 2014. Vol. 66. P. 19–29.
3. Rylnikova M. V., Eremenko V. A., Esina E. N. Destressing of rockburst-hazardous and damaged zones. Gornyy informatsionno-analiticheskiy byulleten. 2014. No. 12. pp. 32–39.
4. Sashurin A. D., Balek A. E., Panzhin A. A., Usanov S. V. Innovative technology for diagnosis of geodynamic activity in geological media and safety assessment of subsoil use objects. Gornyi Zhurnal. 2017. No. 12. pp. 16–20. DOI: 10.17580/gzh.2017.12.03
5. Sashurin A. D., Balek A. E. Improvement of field measurement of stress-deformed state of the large massif parts. Vestnik Permskogo natsionalnogo issledovatelskogo politekhnicheskogo universiteta. Geologiya. Neftegazovoe i gornoe delo. 2014. No. 13. pp. 105–120. DOI: 10.15593/2224-9923/2014.11.11
6. Panzhin A. A. The spatial and temporal geodynamic monitoring at sites subsoil. Gornyi Zhurnal. 2012. No. 1. pp. 39–43.

7. Iofis M. A., Rylnikova M. V. Problems of geomechanical provision of combined geotechnology. Combined geotechnology: scales and prospects of application : materials of international scientific and technical conference. Magnitogorsk : Izdatelstvo MGTU imeni G. I. Nosova, 2005. pp. 88–89.
8. Kodama J., Miyamoto T., Kawasaki S., Fujii Y., Kaneko K. et al. Estimation of regional stress state and Young’s modulus by back analysis of mining-induced deformation. International Journal of Rock Mechanics & Mining Sciences. 2013. Vol. 63. pp. 1–11.
9. Figueiredo B., Cornet F. H., Lamas L., Muralha J. Determination of the stress field in a mountainous granite rock mass. International Journal of Rock Mechanics & Mining Sciences. 2014. Vol. 72. pp. 37–48.
10. Liu C., Gao J. X., Yu X. X., Zhang J. X., Zhang A. B. Mine surface deformation monitoring using modified GPS RTK with surveying rod: initial results. Survey Review. 2015. Vol. 47, No. 341. pp. 79–86.
11. Yan Bao, Wen Guo, Guoquan Wang, Weijun Gan, Mingju Zhang, Jack S. Shen. Millimeter-Accuracy Structural Deformation Monitoring Using Stand-Alone GPS: Case Study in Beijing, China. Journal of Surveying Engineering. 2018. Vol. 144, Iss. 1.
12. Zanutta A., Negusini M., Vittuari L., Cianfarra P., Salvini F. et al. Monitoring geodynamic activity in the Victoria Land, East Antarctica: Evidence from GNSS measurements. Journal of Geodynamics. 2017. Vol. 110. pp. 31–42.
13. Biagi L., Grec F. C., Negretti M. Low-Cost GNSS Receivers for Local Monitoring: Experimental Simulation, and Analysis of Displacements. Sensors. 2016. Vol. 16, Iss. 12. P. 2140.
14. Yigit C. O., Coskun M. Z., Yavasoglu H., Arslan A., Kalkan Y. The potential of GPS Precise Point Positioning method for point displacement monitoring: A case study. Measurement. 2016. Vol. 91. pp. 398–404.
15. Vikulin A. V., Ivanchin A. G. Modern concept of block hierarchy in the structure of geomedium and its implications in geosciences. Fiziko-tekhnicheskie problemy razrabotki poleznykh iskopaemykh. 2013. No. 3. pp. 67–84.

Language of full-text русский
Полный текст статьи Получить
Назад