Journals →  Obogashchenie Rud →  2022 →  #2 →  Back

SECONDARY RAW MATERIAL PROCESSING
ArticleName Processing and use prospects for Inta coals
DOI 10.17580/or.2022.02.07
ArticleAuthor Nifontov Yu. A., Nifontova T. I.
ArticleAuthorData

State Marine Technical University (Saint Petersburg, Russia):

Nifontov Yu. A., Head of Chair, Doctor of Engineering Sciences, Professor, nifontov@yandex.ru
Nifontova T. I., Consultant of Chair, Candidate of Engineering Sciences, Associate Professor, nifontovа_ti@yandex.ru

Abstract

The Inta coal deposit, part of the Pechora coal basin, was discovered in the 1930s. Its coal was processed using the dense medium separation method. The finished products were used exclusively for direct combustion, and therefore no parameter measurements were conducted to establish the respective coal sintering and coking properties. In addition to energy applications, Inta coals may be used to produce fuel briquettes, synthetic liquid fuel, absorbents, semi-coke, carbon-graphite materials, hypercoal, and other products following their respective traditional or combined processing (with thermochemical treatment). Due to the specific physical and mechanical properties of the coal and the use of advanced mining, transportation, and processing methods, the resulting products have high concentrations of fines. When handled at consumption sites, warehouses, and large terminals, the coal is inevitably further disintegrated. Material composition studies of Inta coals confirm their feasibility and applicability, including as agglomerated fuel for layered combustion (briquetting, pelletizing) at medium and small enterprises and in households. It is currently inexpedient to process coal slurries from the Inta industrial region into traditional briquette fuel as it would require the use of more advanced technologies. It is technologically and economically feasible to employ agglomeration technologies without the use of binding materials to produce domestic fuel for local consumption, avoiding long-distance transportation and unnecessary rehandling. This approach is facilitated by the composition of coal fines and the structural peculiarity of briquettes formed.
This work was financially supported by the Ministry of Science and Higher Education of the Russian Federation (agreement No. 075-15-2020-903).

keywords Hard coal, Inta coal deposit, briquetting, coal slurry, briquetting modifiers
References

1. Zhong Q., Yang Y., Li Q., Xu B., Jiang T. Coal tar pitch and molasses blended binder for production of formed coal briquettes from high volatile coal. Fuel Processing Technology. 2017. Vol. 157. pp. 12–19.

2. Mollah M. M., Jackson W. R., Marshall M., Chaffee A. L. An attempt to produce blast furnace coke from Victorian brown coal. Fuel. 2015. Vol. 148. pp. 104–111.
3. Nifontov Yu. A. The structure formation mechanism in wet coal fines briquetting with an active binder. Obogashchenie Rud. 2020. No. 6. pp. 41–46. DOI: 10.17580/or.2020.06.07.
4. Bushnev D. A., Burdelnaya N. S., Kuzmin D. V., Mokeev M. V., Burtsev I. N. Biomarkers of Inta coal deposit, isolation and analysis of chemical structure of hypercoals. Vestnik Instituta Geologii Komi Nauchnogo Tsentra Uralskogo Otdeleniya RAN. 2016. No. 11. pp. 23–30.
5. Gerasimov A. M., Eremina O. V. Application microwave radiation for directional changes of layered silicates properties. Eurasian Mining. 2021. No. 1. pp. 55–60.
6. Nifontov Yu. A., Gerasimov A. M., Burtsev I. N., Karpunina V. P. The issue of processing low-grade coals and getting ash-free coal as a fuel for direct input into the gas turbine. Morskie Intellektualnye Tekhnologii. 2019. No. 3–2. pp. 142–150.
7. Arsentyev V. A., Gerasimov A. M., Dmitriev S. V., Mezenin A. O., Strakhov V. M. New approach to coal preparation of different metamorphism stage. Koks i Khimiya. 2017. No. 12. pp. 26–30.
8. Harionovsky A. A., Kalushev A. N., Vaseva V. N., Symanova E. I. Coal industry ecology: the state, problems, ways of solution. Vestnik Nauchnogo Tsentra po Bezopasnosti Rabot v Ugolnoy Promyshlennosti. 2018. No. 2. pp. 70–81.
9. Ullah H., Liu G., Yousaf B., Ali M. U., Abbas Q., Zhou C., Rashid A. Hydrothermal dewatering of low-rank coals: Influence on the properties and combustion characteristics of the solid products. Energy. 2018. Vol. 158. pp. 1192–1203.
10. Prasad V., Mehrotra S. P., Thareja P. Influence of additives, particle size and incorporation of coarse particles on the shear rheology Indian coal ash slurries. Asia-Pacific Journal of Chemical Engineering. 2019. Vol. 14, Iss. 5. DOI: 10.1002/apj.2358.
11. Olykainen A. M., Shurekov N. A. Coal deposits of the Inta region (Pechora basin). Inta, 1997. 292 p.
12. Uryev B. N. Physico-chemical dynamics of dispersed systems and materials. Moscow: Intellect, 2013. 232 p.
13. Blekhman I. I. Vibrational mechanics and vibrational rheology. Theory and applications. Moscow: Fizmatlit, 2018. 752 p.
14. Gerasimov A. M., Grigoryev I. V., Ustinov I. D. Measurement of slope angles for granular materials. Obogashchenie Rud. 2020. No. 4. pp. 48–52. DOI: 10.17580/or.2020.04.08.
15. Petrov A. V. Technology of heat treatment and agglomeration of manganese concentrates. Krivoy Rog: Publishing House of R. Kozlov, 2019. 517 p.

Language of full-text russian
Full content Buy
Back